sample wanpipe1.conf

Owned by Nathaniel Halbrooks
Jan 08, 2024
2 min read
#================================================ # WANPIPE1 Configuration File #================================================ # # Date: Wed Dec 6 20:29:03 UTC 2006 # # Note: This file was generated automatically # by /usr/local/sbin/setup-sangoma program. # # If you want to edit this file, it is # recommended that you use wancfg program # to do so. #================================================ # Sangoma Technologies Inc. #================================================ [devices] wanpipe1 = WAN_AFT_TE1, Comment [interfaces] w1g1 = wanpipe1, , TDM_VOICE, Comment [wanpipe1] CARD_TYPE = AFT S514CPU = A CommPort = PRI AUTO_PCISLOT = NO PCISLOT = 4 PCIBUS = 5 FE_MEDIA = E1 FE_LCODE = HDB3 FE_FRAME = CRC4 FE_LINE = 1 TE_CLOCK = NORMAL TE_REF_CLOCK = 0 TE_SIG_MODE = CAS TE_HIGHIMPEDANCE = NO TE_RX_SLEVEL = 430 HW_RJ45_PORT_MAP = DEFAULT LBO = 120OH FE_TXTRISTATE = NO MTU = 1500 UDPPORT = 9000 TTL = 255 IGNORE_FRONT_END = NO TDMV_SPAN = 1 TDMV_DCHAN = 0 TE_AIS_MAINTENANCE = NO #NO: defualt YES: Start port in AIS Blue Alarm and keep line down #wanpipemon -i w1g1 -c Ttx_ais_off to disable AIS maintenance mode #wanpipemon -i w1g1 -c Ttx_ais_on to enable AIS maintenance mode TDMV_HW_DTMF = YES # YES: receive dtmf events from hardware TDMV_HW_FAX_DETECT = YES # YES: receive fax 1100hz events from hardware HWEC_OPERATION_MODE = OCT_NORMAL # OCT_NORMAL: echo cancelation enabled with nlp (default) # OCT_SPEECH: improves software tone detection by disabling NLP (echo possible) # OCT_NO_ECHO:disables echo cancelation but allows VQE/tone functions. HWEC_DTMF_REMOVAL = NO # NO: default YES: remove dtmf out of incoming media (must have hwdtmf enabled) HWEC_NOISE_REDUCTION = NO # NO: default YES: reduces noise on the line - could break fax HWEC_ACUSTIC_ECHO = NO # NO: default YES: enables acustic echo cancelation HWEC_NLP_DISABLE = NO # NO: default YES: guarantees software tone detection (possible echo) HWEC_TX_AUTO_GAIN = 0 # 0: disable -40-0: default tx audio level to be maintained (-20 default) HWEC_RX_AUTO_GAIN = 0 # 0: disable -40-0: default tx audio level to be maintained (-20 default) HWEC_TX_GAIN = 0 # 0: disable -24-24: db values to be applied to tx signal HWEC_RX_GAIN = 0 # 0: disable -24-24: db values to be applied to tx signal [w1g1] ACTIVE_CH = ALL TDMV_HWEC = YES MTU = 8

 

Return to Documentation Home I Return to Sangoma Support