Vega 50/60G BRI with a Generic PBX

The following Guide will help you configure your Vega 50 FXO for an IP PBX
 

 

The SIP trunk between the Vega and the IP-PBX must be configured as an non-authenticated and non-registrar connection

  

  1. Log into the Vega gateway using the WebUI interface. The default user is admin and password is admin.

  2. As the Vega gateway WebUI loads up the Status page as shown below.  Once the page has finished select the "Quick Config" menu option as shown below:

  3. The WebUI will present a warning message please read the message and then select "Continue" on the screen below.

  4. Once the Quick Config UI has loaded should select the Basic Config Tab.

 

You must specify the correct country or the Vega will not be able to recognise the tones for you Telephone lines

  1. Once the Basic config is completed should select the VoIP tab.  The screen shot below highlights the most important fields.

  1. Click on the BRI tab to being configuring your BRI ports and their call route

 

Telephone number list- This is configured as ".*" which is routing terminology for any called party number string of characters with any length of characters.  
                                       The field defines which telephone numbers will route out to the BRI trunk interface

                                       The Telephone number list will need to be configured for EACH BRI port that is being used

NT? Defines whether each interface should be configured as NT or TE (eg The Vega will be emulating a telco and so should be set to NT mode)
       This field should be configured for EACH BRI port that is being used (by default BRI ports 2 and 4 are NT mode)

The parameters to be configured by Quick config are complete - select the "Submit" button.

The Quick Config Submit creates a popup Click "OK" on the next window to apply the settings.

 

NOTE The save process creates a  select "Continue" on this window. 

 

 

Return to Documentation Home I Return to Sangoma Support