FreePBX HA-PCS Status

CLI Command

• From the CLI, we can run pcs status to see the current status of the cluster.

  • pcs status

Open

Normal Results

• Below is a full output of a PCS Status with no error.

Open

Errored Results

• Below is a full output of a PCS Status with error.  We can see at the bottom that "Asterisk Service" had failed at some point on "freepbx-a server, but PCS was able to restart the service. Just above the Failed Actions, we see that Asterisk Service is running again on the freepbx-b server.

• With an error showing for the asterisk service on freepbx-a server, PCS will not be able to move asterisk back over to freepbx-a server until you clear out this error. To clear out this error, we will use the following command.   This tells it to clear any errors with the asterisk_service on any server. 

  • crm_resource --resource asterisk_service -C

• To clear the error on a specific server only, we would use the following command. Note the freepbx-a at the end of the command. We are clearing any asterisk_service errors on freepbx-a server only.

  • crm_resource --resource asterisk_service -C --node=freepbx-a