PBX GUI - AMI Through Telnet.

Sometimes you need to check AMI connection. But how?

You can use Putty.exe or telnet as well.

With Putty.exe (For Windows), set these parameters like this:
Save your settings and connect and you should get a result like that.
Once connected, then you need to login in. (<crlf> = Key Enter)
Action: login<crlf> Username: admin<crlf> Secret: xxxxxxxxxxxxxxxxxxxxxxxxxxx<crlf> <crlf> Response: Success Message: Authentication accepted Event: FullyBooted Privilege: system,all Status: Fully Booted ACTION: COMMAND<crlf> command: core show hints<crlf> <crlf> ACTION: COMMAND command: core show hints Response: Follows Privilege: Command -= Registered Asterisk Dial Plan Hints =- 100@ext-local : PJSIP/100&Custom:DND State:Idle Presence: Watchers 1 101@ext-local : SIP/101&Custom:DND10 State:Unavailable Presence: Watchers 0 102@ext-local : SIP/102&Custom:DND10 State:Idle Presence: Watchers 1 103@ext-local : SIP/103&Custom:DND10 State:Unavailable Presence: Watchers 0 207@ext-local : PJSIP/207&Custom:DND State:Unavailable Presence: Watchers 0 206@ext-local : PJSIP/206&Custom:DND State:Unavailable Presence: Watchers 0 205@ext-local : PJSIP/205&Custom:DND State:Unavailable Presence: Watchers 0 204@ext-local : PJSIP/204&Custom:DND State:Unavailable Presence: Watchers 0 203@ext-local : PJSIP/203&Custom:DND State:Idle Presence: Watchers 0 202@ext-local : PJSIP/202&Custom:DND State:Unavailable Presence: Watchers 1 201@ext-local : PJSIP/201&Custom:DND State:Idle Presence:available Watchers 1 *8575@park-hints : park:75@parkedcalls State:Unavailable Presence:not_set Watchers 0 .../... ---------------- - 74 hints registered --END COMMAND--

Sometimes you might get an error caused by a wrong character somewhere in the console, just press key Enter, and try to write your command again. In this example, I formatted the result of core show hints, there's no <crlf> in this result. Ref: Asterisk Manager API - VoIP-Info

With telnet, same thing. Just launch # telnet ip_address 5038