A-Series & DECT Phones Auto-Provision Quick Start Guide

Open

Congratulations on being the newest member to the Sangoma IP Phone Family!

Where do I start?

There are a few diffierent ways to setup Sangoma phones.  Please select from one of the below

We recommend you select Option 1 above.

Setting up Sangoma Phone(s) with our redirection service offers true Zero-Touch provisioning.  This process allows the phone to auto-discover FreePBX / PBXact and auto-provision itself, simply by un-boxing a new phone and connecting its Ethernet cable to the network.

Other Benefits of using our Redirection Service:

• Allows end-user to setup their own phone by simply connecting it to the network. No manual configuration !

  • eliminates requirement of on-site IT administrator

  • Enables remote office workers to setup their own phone by simply connecting phone to the Internet

  • Easy relocation of phone without any manual configuration

  • Simply plug the Ethernet Cable into the phone, power it up and it auto-provisions

Boot Procedure of a NEW Sangoma Phone

Upon initial boot of a NEW Sangoma phone, it will attempt the following procedure in the order listed, until one is successful:

1. PnP service:  The Phone will attempt to find the FreePBX / PBXact system by sending a multicast discovery on the network. 
   Note: For PnP service to be successful the FreePBX / PBXact must be on the same network segment as the phones, AND must have sysadmin 13.0.73 and above.  

2. "Option 66" (feature of your company DHCP server if enabled). 

3. Redirection service:  Phone will try and contact Sangoma's redirection service at rs.sangoma.net and see if your phone has been setup with a redirect to your PBX. In the event it can not reach the Redirect Server or the Redirect Server has not been setup for your phone the phone will continue to boot up but it will have no information on how to reach your PBX.