Fonality - Configure Cisco RV180w or 220w Routers
- Kelli Higdon
Configuring/Provisioning router settings on the Cisco RV180W/220W to Fonality Standards
Configured for Fonality Managed Hosted Services
Cisco RV180W -- up to 25 concurrent calls
Cisco RV220W -- up to 50 concurrent calls
QOS Setup Cisco RV180W/220W Description: QoS Router - Cisco RV180W(NEW) RV220W(NEW)
(The factory default combination is User:cisco Pass:cisco)
If the device is Fonality Provisioned, you will need to contact support for the login. We don't want to publicly publish it here.
If you end up on the 'Router Setup Wizard' page, exit it by pressing cancel.
Use the steps below to configure the router:
***Create new service in Firewall that defines UDP 10000-20000 as FonalityVoIP***
***QoS settings***
Enable WAN QoS
set WAN QoS Mode -> Priority
Total WAN (Internet) Bandwidth - should be set to measured upload bandwidth per customer.
Add WAN QoS profile "VoIP" - Priority "High"
***Profile binding Settings***
Available profile VoIP
Service FonalityVoIP
Traffic Selector Match type "IP address Range"
Starting and Ending IP address should include entire local range
***Disable WiFi***
Administration > Management Interfaces> User Accounts
For advanced troubleshooting steps, please view the troubleshooting article:
Cisco-RV180W-220W-Troubleshooting
Misspelled Words (Do Not Remove): RV180 RV-180W RV-180 180W 180 RV RV220 RV-220R RV-220 R-V220 220 220W