IMG 1010 - DS3 Span Profile - 10.5.x
- Kelli Higdon
Â
Description:
Once the DS3 Interface has been created, each individual DS1 will need to be configured. Follow the procedure below to accomplish this.
Accessing this Pane:
Dialogic IMG EMS -> Logical IMG -> Physical IMG -> Facility -> TDM DS3 > TDM Spans
Maximum Objects:
1 per Physical IMG
Related Topics:
 IMG 1010 - DS3 Physical Span Configuration - 10.5.x
ClientView Pane:
Field Descriptions
Interface:
The interface will default to Bearer and cannot be changed
Offset - x Configuration:
Each individual Span can be configured by a drop down menu. Below are the drop down menu selections.
Not Used- The Span will not be used
Local Loopback- Loops back transmit and receive on that individual span so that a far end piece of equipment can send a test such as a BERT test towards the local IMG. The span on the front panel of IMG 1010 will blink orange when offset is in local loopback.
Remote Loopback (CBIT only)- The local IMG sends out a FEAC code to a far end piece of equipment telling an individual span to go into loopback mode (Loopback Transmit and Receive) so the local IMG can send out a test such as BERT test. The span on the front panel of IMG 1010 will display solid orange when offset is in remote loopback.
Profile- This will be a drop down menu of all the TDM profiles created under the Profiles Object in ClientView. In screen capture above the IMG is configured for T1 over DS3.
Following the request to put DS1 offset 14 in loopback, you CANNOT make another request for loopback on another span without first taking span 14 out of loopback.
Monitoring Fields:
Available Span Count:
The number of Spans available and not being used
Licensed Span Count
Number of DS3 Spans licensed
Buttons:
Facility Wizard:
If the facility wizard button is clicked the a dialog box will appear allowing you to configure a range of spans instead of configuring each individual span. Below is screen capture of the facility wizard dialog box that will appear.
Â
Profile - Select from a drop down list all the TDM profiles created under the Profiles object in ClientView
Start Interface ID - Select from a drop down menu the starting Span
Span Count - Select from a drop down menu the number of spans to configure