Overview

The Logo LED in the top center of the S500 and S700, can be set to 3 different backlit states.

Setting Logo LED Backlight

• You can set the Logo LED backlight settings using the PBX EndPoint Manager.

• Go into End Point Manager in your PBX and select the Sangoma brand in the menu.

Open

• Click on the template in End Point Manager that you want to modify.

Open

• Click on the Options menu tab at the top
   

  Open

  

• There are three available Logo LED backlight settings.
  
  

  Open

  

  • Tie to Backlight - uses the Backlight Timeout setting.  When you screen dims, so will the logo LED.

  • Always On - the logo LED will always be lit, even during screen saver or backlight dim times.

  • Always Off - the logo LED will always be off.

• You now need to update the phone configuration file. The three options at the bottom of the template are:

Open

• Save Template- This will only save your changes into the PBX database. It will not write out new config files for the phones that are using this template as mapped in the Extension Mapping section of End Point Manager.

• and Rebuild Configs- This will save your changes to the PBX Database and will also write out new config files for the phones that are using this template as mapped in the Extension Mapping section of End Point Manager. The phones will need to be rebooted in order to retrieve the changes.

• and Force Update- This will do both the "Save Template" and the "and Rebuild Configs" options above, and it will also immediately update any phones that are mapped to use this template and currently registered to the PBX, with no need to reboot the phones.