/
Open Source - Dahdi firmware not available from userspace
Open Source - Dahdi firmware not available from userspace
The most common cause for this problem is that the firmware file truly isn't in the directory where the system is looking for it. Check the following locations:
/lib/firmware/
/usr/local/lib/firmware
/usr/lib/hotplug/firmware
If the firmware is present, but still not being loaded, the following steps may help:
Download DAHDI source tarball. http://downloads.asterisk.org/pub/telephony/dahdi-linux/dahdi-linux-current.tar.gz
Edit the file "Makefile"
Locate the line that starts "HOTPLUG_FIRMWARE:=" and set "HOTPLUG_FIRMWARE:=no"
Compile and install DAHDI as normal from here.
When finished, reload DAHDI or reboot the server. If the driver still throws an error after this step, contact Digium Technical Support.
, multiple selections available,
Related content
Open Source - Installing DAHDI
Open Source - Installing DAHDI
More like this
Open Source - How to Download and Compile DAHDI on CentOS
Open Source - How to Download and Compile DAHDI on CentOS
More like this
Open Source - Unable to create channel of type 'DAHDI' (cause 0 - Unknown)
Open Source - Unable to create channel of type 'DAHDI' (cause 0 - Unknown)
More like this
How to confirm if DAHDI supports a Digium card
How to confirm if DAHDI supports a Digium card
More like this
Phones - Firmware Configuration Management with DPMA
Phones - Firmware Configuration Management with DPMA
More like this
Support Services - How to solve failure to write to disk while upgrading phone firmware
Support Services - How to solve failure to write to disk while upgrading phone firmware
More like this